# Returning to start position

**URL:** <https://forum.lightburnsoftware.com/t/returning-to-start-position/26931>\
**Category:** LightBurn Software Questions\
**Created:** [November 27, 2020, 12:35pm UTC](https://forum.lightburnsoftware.com/t/returning-to-start-position/26931 "2020-11-27T12:35:51Z")\
**Posts on this page:** 4\
**Page:** 1

<div class="post-metadata">

**Author:** ![Bulldog](https://forum.lightburnsoftware.com/user_avatar/forum.lightburnsoftware.com/bulldog/32/99263_2.png) [@Bulldog](https://forum.lightburnsoftware.com/u/Bulldog)\
**Post date:** [November 27, 2020, 12:35pm UTC](https://forum.lightburnsoftware.com/t/returning-to-start-position/26931/1 "2020-11-27T12:35:51Z")

</div>

Is there a setting to change speed at which laser "Returns to Start Position’  
Thanks

---

<div class="post-metadata">

**Author:** ![LightBurn](https://forum.lightburnsoftware.com/user_avatar/forum.lightburnsoftware.com/lightburn/32/75577_2.png) [@LightBurn](https://forum.lightburnsoftware.com/u/LightBurn)\
**Post date:** [November 28, 2020, 5:05am UTC](https://forum.lightburnsoftware.com/t/returning-to-start-position/26931/2 "2020-11-28T05:05:24Z")

</div>

If you’re using a GRBL controller, it’s the default rapid speed, which is the maximum travel rate of the controller as set in the firmware. You can override that by issuing a G0 Fxxxx comand when you power up to change the G0 feed speed, where xxxx is in mm/minute.

---

<div class="post-metadata">

**Author:** ![Bulldog](https://forum.lightburnsoftware.com/user_avatar/forum.lightburnsoftware.com/bulldog/32/99263_2.png) [@Bulldog](https://forum.lightburnsoftware.com/u/Bulldog)\
**Post date:** [November 28, 2020, 5:20pm UTC](https://forum.lightburnsoftware.com/t/returning-to-start-position/26931/3 "2020-11-28T17:20:38Z")

</div>

Thank you Oz ✌

---

<div class="post-metadata">

**Author:** ![system](https://forum.lightburnsoftware.com/user_avatar/forum.lightburnsoftware.com/system/32/64335_2.png) [@system](https://forum.lightburnsoftware.com/u/system)\
**Post date:** [December 28, 2020, 5:20pm UTC](https://forum.lightburnsoftware.com/t/returning-to-start-position/26931/4 "2020-12-28T17:20:45Z")

</div>

Closed on December 28, 2020, 5:20pm UTC

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.