# Rotary Chuck Stalling and Restarting

**URL:** <https://forum.lightburnsoftware.com/t/rotary-chuck-stalling-and-restarting/174009>\
**Category:** Community Laser Talk\
**Tags:** rotary, xtool-d1, ortur, xtool\
**Created:** [June 23, 2025, 3:15pm UTC](https://forum.lightburnsoftware.com/t/rotary-chuck-stalling-and-restarting/174009 "2025-06-23T15:15:53Z")\
**Posts on this page:** 1\
**Showing post:** 2

<div class="post-metadata">

**Author:** ![ednisley](https://forum.lightburnsoftware.com/user_avatar/forum.lightburnsoftware.com/ednisley/32/40455_2.png) [@ednisley](https://forum.lightburnsoftware.com/u/ednisley)\
**Post date:** [June 23, 2025, 4:48pm UTC](https://forum.lightburnsoftware.com/t/rotary-chuck-stalling-and-restarting/174009/2 "2025-06-23T16:48:43Z")

</div>

> [@Apples](#):
>
> issues with the rotary chuck stopping and restarting

[The rotary](https://ortur.net/products/ortur-y-axis-rotary-chuck) looks like it has a belt or gear reduction drive, so check for crud / dust / whatever packed into the drive train. Also look for wear: does the belt / gearing have any teeth left?

A too-high axis acceleration value can cause the motor to stall briefly, particularly when combined with a bit of junk in the drive train. If you’re using the same acceleration on the rotary as with the linear Y axis, reduce it by a factor of ten, which will not have much effect on the rotational performance.

You _may_ be able to compensate for too-high acceleration by dramatically reducing the Y axis speed, but that also requires changing the machine settings. Reducing the LightBurn layer speed won’t help, because that will reduce the scanning speed on the X axis.

Unfortunately, xTool has a _terrible_ history when it comes to modifying the firmware configuration settings to improve on their defaults. This lengthy discussion covers some of the problems in a situation like yours:

> [@Losing alignment when traveling, can't make acceleration change write to hardware, xTool D1](https://forum.lightburnsoftware.com/t/losing-alignment-when-traveling-cant-make-acceleration-change-write-to-hardware-xtool-d1/54871/):
>
> Hi Lightburn laser wizards, I am having serious problems with my new xtool D1. Below is a copy of what I sent xTool tech support, but essentially, when the laser FAST travels between shapes I will hear an angry noise from the stepper motor and it will print 3-6 mm off of alignment from then on. I am trying running to 80% of max speed with “motion limit” on to mitigate but it still happens once per hour sometimes. I’m glad I’m configuring with inexpensive materials, would LOVE any tips! -----…

If keeping the drive train clean & orderly doesn’t help, the next steps will be difficult. Other folks may have suggestions, but xTool firmware seems immune to many of the common solutions.

---

_[View the full topic](https://forum.lightburnsoftware.com/t/rotary-chuck-stalling-and-restarting/174009)._
