Hello!! I have watched the vids on youtube about setting up a rotary. I am running ruida controller and Lightburn software on a Thunder Nova 35, 80 watt. The rotary I have is from Hj Laser. Randy has been a godsend too!!
I have made a box, 2 inches square and my machine cuts a basic line. Thats it. This is with the steps per rotation set at 300. Upon reading more, I made my drawing longer and the cut was finally getting bigger. However my drawing was at the 24inch mark and my cut was only about an inch and a half. I moved my steps per rotation back to 10000 and it th=rew the mug off the rotary…
I am really missing some setting and i cannot find the setting.
Thanks to all!!
David Kelly