Scaling wrong after stop

LightBurn Software Questions
1

Hi Guys
I have been using this program for 8 months everything tip top
now i had to cancel an engraving and now the scaling of the y-axis is no longer correct. when i manually enter y100 in the console, the laser also moves 100mm, but when i create a circle in the program of x100 y100, i have an oval of 100mm x 125mm

for example, i can also enter the maximum values and drive to the edge. but if I use the corner points of the grid, it goes beyond

2

Make sure you don’t have rotary mode enabled - that’s almost always the issue if the Y axis is scaled wrong. If that isn’t it, check that your step settings for the Y axis haven’t changed.

3

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.