Tested this again today and can confirm, scanning offset adjust is not working on my machine.
RDC6442S-B(ec) latest firmware. LB 0.9.02
Top cut is no adjust entries. Bottom is as pictured in the screenshot.
Any suggestions?
George
Tested this again today and can confirm, scanning offset adjust is not working on my machine.
RDC6442S-B(ec) latest firmware. LB 0.9.02
Top cut is no adjust entries. Bottom is as pictured in the screenshot.
Any suggestions?
George
You want to use “Line Shift”, not “Initial Offset”.
D’oh! That explains it.
Thanks
George
Not perfect, but best results yet. It’s taken over a year to finally engrave a decent looking letter A into this Rowmark material. What an ordeal it’s been.
Top is 7mm high, then 4mm and 3mm.
George
This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.