I set the size of a rectangle to 7.5 x 11 inches. When I hit frame the laser wasn’t even close to those dimensions. I finally got the laser to frame the 7.5x11 by changing the settings to 9x12 inches. What’s going on?

Any chance the Rotary was accidently turned on?

You are absolutely correct. I just got done with the rotary and didn’t change the settings. Thank you.

Good to know, Thanks. All I have to do now is remember it.

[image] DBat: All I have to do now is remember it. Memory requires three passes: “How can anybody know that?” “Oh, that again.” “Doesn’t everybody know that?” :grin:

LightBurn Software Forum

Setting tool size

LightBurn Software Questions

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled