My last job, a gift for a friend.
K40 minigerbil, 2x3mm HDF, 23% -ca.7mA, 2 passes
!!!All designs are made with LightBurn, of course!!!
n
5 Likes
I love the use of this type of joinery. Very good work!
Was this one of those moments at the end where you double take and think “how did that happen”?
I checked to make sure Desig wasn’t perhaps a Danish word.
… I have seen it while I put on the net …
therefore the small “n” under my description
- no Danish special word
Jeff,you must not use your pixel magnifier for everything!
1 Like
thank you 
1 Like