Hi I have a sculptfun 10w laser and a ROG laptop. When I have my frame all set and hit start it takes a really long time before it starts (like an hour). I’m cutting a 12”x8” rectangle with additional cuts to make (6) 4”x4” squares that each have a basic image on them (a cross). It goes from 0 to 26% in a few seconds but will slowly go from 26%-38ish% (in about an hour) then jumps to 100% And begins cutting/engraving
Can you upload your file? Does this do it on all projects?
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.