Sorry if this has been covered, I must not have the right terminology?

LightBurn Software Questions
1

I know I have seen a video of this in the past. I must not be using the correct words to get it to come up.

I have created a jig for craft sticks. I want to be able to setup Lightburn to line up the same every time I need to use it.

The video I saw created two little targets and set Lightburn to identify the position of each target, thus letting the software know the positioning of the jig to allow reproducing the same positioning results each time using said jig.

I hope I explained what is in my head well enough, if not feel free to ask questions.

Thank you in advance,
Eric

1 Like
2

Print and Cut is what you’re looking for. Here is the lightburn Documentation on that feature.

I just did a video the other day that shows using this with a jig for placement. Check it out if interested.

2 Likes
3

Thank you, this is exactly what I needed.

2 Likes