Hi members i am a beginner asking for help i just use lightburn and when i laser letters these go at 3000mm / min speed and can adjust the speed too.
See movie 1.
Lettering gcode movie
But when I load a photo into lightburn and save it as gcode and start it up it goes very very very slow, I know that a photo has more dpi.
But my speed in lightburn is 3000mm / min and it should go very fast but it is so slow.
See movie 2
Photo gcode movie
Who knows, based on my setting photos and videos, maybe whether I have something wrong.
I have a diode Optlasers 6 watts.
I hope there is someone who can help me with this I am stuck and do not know how to proceed.
My settings photos maybe i did something wrong there, if so can anyone make adjust on photo in paint so i can learn how it must be .
Or i maybe have a page forget in foto that i must have to correct the settings i hope anyone can place it in comments.
Thanks for helping.