My laptop recently died and I’ve had to switch over to a new one. Setting up the programs, including lightburn, and so now have the latest 2.0.02. My speed units are defaulting to inches vs mm and I cannot figure out how to switch them back. I know the older software had a simple setting to do this - and I see the one for design units but not speed units. I’ve included a photo of what my units settings looks like now. Any suggestions? (Also, I’ve searched as best I can and didn’t see an answer for this so apologies if it’s repetitive!)
Just look at this post from today ;-), here are pictures where you can change your units of measurement for the design and for the machine.
Thank you!! 
I’m not at all surprised it was somewhere, I figured it was user search error 
You’ve read the link, then you’ve also read that I couldn’t find it either (again) and I thought I knew LB reasonably well. 
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.