Starting point when cutting

[vladst2004 (vlad)]

Hello. Is there any way to select a starting point where to start cutting. For example if I cut a letter ( R ) it starts from the middle of the curve … and it would be desired to start from a corner. Can I do any setup >??Thank you

[berainlb (PY)]

This question was asked just yesterday. See here:

Start/Stop line

You can use the “set shape start point” tool to control where the entry point starts. It’s the tool near the bottom of the left side toolbar. [image] You may need to ungroup objects if you are working with nested shapes. Also, make sure that the optimization setting for “choose best starting point” is not enabled or what shows there could be overrided. However, any manual change will not get overriden even with that option selected.

[vladst2004 (vlad)]

Thank you SO much !!!