Stoke/offset at engrave

this is more of a software idea/suggestion.

I was wondering if it’s possible to add a stroke option. With many of our designs, we have fonts that are quite small that we have to manually offset just to give them a bit more bite - but obviously, when you do this you lose the ability to edit and it converts them to curves.

A stroke option or an “offset at engraving” option would be amazingly useful.

thanks all!

LightBurn has a Feature Suggestion site:

If your suggestion is already there by all means, upvote it.
If your suggestion is new ( I think it is… ) post it there to increase discussion and interest.

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.