HI, I am new to the forum and to Lightburn and Laser engraving.
Sometimes I get these stray lines that burn on my project but they are not on the design .
Where do they come from and how do I get rid of them .
seeing how nobody responded to your issue similar to mine I don’t feel confident that ill get a response either. How have u resolved the issue if you did that is. I dont have the same issue with letters though it may happen also i havent tried letters but im dealing with the issue when using line boxes.
I’d been skipping over Ruida controller questions because I don’t have one and I don’t know them very well.
@pam - Can you post a picture of what the stray lines look like. The solution is going to be very different from the one I offered @ImmortalHybrid a handful of minutes ago. There are different actions that the Ruida Controller takes to control power output.
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.