I recently switched from using Ezcad2 on my Cloudray QS30 laser to Lightburn. While using ezcad2 the laser ran fine and engraved as it should, but now it does not actually mark what I am working on. It will turn on and give me the outline (frame) but that’s as far as it goes. I’ve watched the installation video a few times and imported the files from ezcad as well as installed the ezcad2 driver. Am I missing something?
edit - speed was at 10 mm/m and I didn’t notice that…
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.