Text is lasered, PNG breaks off

[ednisley]

@yamu93

GPIO isr service is not installed

This may be a controller firmware problem:

Laser homing frequently hangs Lighburn

I followed up with Creality and asked for the previous firmware version. They sent me 3.0.20, so I downgraded from the 3.0.24 current version, and the Falcon is flying! I can now home repeatedly without a lockup and the Console returns abundant data (see below). Even the cuts look cleaner. If you have a Creality CR Falcon 10W and are having problems like the above, it’s probably the firmware. Thanks again @berainlb ! $H b dir:3 head:21 tarx=-660.000000 tary=-660.000000 xmm=-52800 ymm=-52…

The Creality support folks should have more details on what’s going on and what will fix it.