Please help
What should be set to make a burnt circle, square, etc. they had a common beginning and end point. Now it is a slight gap of about 1mm.
I found a similar topic on the forum. But there is no description of where such settings are in lightburn.
Proszę o pomoc
Co należy ustawić żeby było wypalone koło, kwadrat itp. miały one wspólny punkt początkowy i końcowy. Teraz jest niewielka szczelina około 1mm… Znalazłem podobny temat na forum. Ale nie ma opisu, gdzie takie ustawienia są w Lightburn.
Read this doc hope it helps.
1 Like
1 Like
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.