The machine lagged during prosses

[NicholasL (Nicholas Leqeta)]

Ok thanks,

Have you had this laser module running ok previously?

Have you seen this topic?:

Configuring a 3018 CNC (or other CNC-based laser) for use with LightBurn

The summary: Turn on Laser Mode to get rid of the travel lines You’re trying to move too fast, which is why you don’t get enough power You need to zero the machine 3018’s are pre-configured for use as CNC machines, not lasers, so their settings and speeds will likely need to be changed to give you acceptable results with LightBurn. To see the existing settings, you can type $$ into the console in LightBurn and press enter, or go to Edit > Machine Settings. Both are showing the same values, b…

We first need to check if the GRBL parameter $32=1

Please go to your LightBurn>Window>Console, and enter these commands, one line at a time, and press “enter” after each:

$i
$$
?

Select and copy the results from the console window and then paste them back here please.