# Too powerful co2 laser?

**URL:** <https://forum.lightburnsoftware.com/t/too-powerful-co2-laser/130015>\
**Category:** Community Laser Talk\
**Created:** [February 17, 2024, 2:30pm UTC](https://forum.lightburnsoftware.com/t/too-powerful-co2-laser/130015 "2024-02-17T14:30:46Z")\
**Posts on this page:** 1\
**Showing post:** 2

<div class="post-metadata">

**Author:** ![ednisley](https://forum.lightburnsoftware.com/user_avatar/forum.lightburnsoftware.com/ednisley/32/40455_2.png) [@ednisley](https://forum.lightburnsoftware.com/u/ednisley)\
**Post date:** [February 17, 2024, 2:46pm UTC](https://forum.lightburnsoftware.com/t/too-powerful-co2-laser/130015/2 "2024-02-17T14:46:53Z")

</div>

> [@rowimic](#):
>
> Have i made my biggest mistake

Nah, not at all.

The current through a CO₂ laser tube determines the output optical power, more-or-less linearly proportional to the percent power setting in the LightBurn layer, so you can set the power to suit whatever you’re doing.

However, each tube has a _minimum_ current at which it will operate, thus setting the lowest power the tube can produce. That current depends on the tube’s:

- _Maximum_ current rating
- Temperature
- Age

There are also [peculiarities involved at very low power levels](https://forum.lightburnsoftware.com/t/where-those-random-dots-in-engravings-come-from/78922), but those are common to all CO₂ lasers and their power supplies.

The lens also matters, with various focal lengths producing various spot sizes, but that’s likely secondary to a well-aligned optical path with good mechanical setup.

Basically, run a bunch of test patterns to see what the machine does; you’ll likely find it works better than the doomsayers would have you believe and you won’t run into its limitations for a long time.

Worst case, it doesn’t make exactly the thing you wanted, but it cranks out a _perfect_ moneymaker you never expected. 😁

---

_[View the full topic](https://forum.lightburnsoftware.com/t/too-powerful-co2-laser/130015)._
