Tool change issue

[wanderingtruckie (terry - oval lane creations)]

just seen this video

How to modify the custom gcode flavor

Hello, I’m very interested in Millmage. I’m sure I can run it at home, but I’d love to offer it as an option at work as well. The problem is that my controller at work is a Syntec controller and would normally work as just outputting gcode, but the problem is that in Syntec controllers, it uses g70 / g71 for inch / metric and not g20 / g21. I was wondering if there’s a way to modify and load your own post processor / flavor into millmage (yet) or if it’s a future option. TIA

at 3.10m mark he says a @P for a pause command not a M0 ?
is the @ MM way of commanding board to pause