DodgerRN
(Neil long)
August 22, 2020, 5:18pm
1
If I delete the prefs folder uninstall lightburn and disconnect my 3018. Then reinstall lightburn will that hard reset to install preset. Then reinstall my 3018. As I’m having problems with power settings on the laser being all to hell etc.
It would reset everything, but it’s unlikely to solve your issues. Read the blurb here about trying to run too fast (about 1/2 way through):
The summary:
Turn on Laser Mode to get rid of the travel lines
You’re trying to move too fast, which is why you don’t get enough power
You need to zero the machine
3018’s are pre-configured for use as CNC machines, not lasers, so their settings and speeds will likely need to be changed to give you acceptable results with LightBurn.
To see the existing settings, you can type $$ into the console in LightBurn and press enter, or go to Edit > Machine Settings. Both are showing the same values, b…
system
(system)
Closed
September 5, 2020, 5:54pm
3
This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.