# Totally stuck after a long break away from laser

**URL:** <https://forum.lightburnsoftware.com/t/totally-stuck-after-a-long-break-away-from-laser/52762>\
**Category:** Getting Started With LightBurn\
**Created:** [November 26, 2021, 11:05am UTC](https://forum.lightburnsoftware.com/t/totally-stuck-after-a-long-break-away-from-laser/52762 "2021-11-26T11:05:39Z")\
**Posts on this page:** 1\
**Showing post:** 20

<div class="post-metadata">

**Author:** ![berainlb](https://forum.lightburnsoftware.com/letter_avatar_proxy/v4/letter/b/85f322/32.png) [@berainlb](https://forum.lightburnsoftware.com/u/berainlb)\
**Post date:** [December 7, 2021, 8:55pm UTC](https://forum.lightburnsoftware.com/t/totally-stuck-after-a-long-break-away-from-laser/52762/20 "2021-12-07T20:55:40Z")

</div>

Inversion issues are usually tied to Device Setting origin issues.  
 ![image](https://forum.lightburnsoftware.com/uploads/default/original/3X/2/7/27acdf3bcd52e0300f229c58ee224655d626937d.png)

How is yours currently configured? I believe this should be lower-left for your system.

I found a few topics that seem to address many of the specific challenges you’re seeing with your machine. Check this out. This links to other very relevant topics:  
[Setting the machine origin - Getting Started - LightBurn Software Forum](https://forum.lightburnsoftware.com/t/setting-the-machine-origin/12406)

---

_[View the full topic](https://forum.lightburnsoftware.com/t/totally-stuck-after-a-long-break-away-from-laser/52762)._
