Bertus
May 23, 2021, 11:26am
1
Hey
raykholo
May 26, 2021, 2:29am
3
Have you reviewed our GRBL setup guide as a starting point?
This explains your speed limit issue:
What might be happening is that you could be commanding the laser to move much faster than it actually can. Your maximum rate settings ($110, $111) are set to 1000 mm/min, which is 16.66 mm/second, or in layman’s terms, slower than molasses flowing uphill in January.
If you tell the software to try to move faster than that, the laser mode you’ve now enabled will reduce the power to compensate for the fact that it isn’t allowed to go as fast as you’ve requested. If you try running a cut at 15m…
system
July 7, 2021, 7:23am
5
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.