Transversal lines burning

[pattymoelle]

I have a universal 30000 mw laser 60 x 60. It is burning the tranverse lines. I am new to all of this. Also everything is burning in a mirror image. Please help

[Rick (Technical Evangelist)]

Welcome. We provide search on this forum which will return many results for your questions.

Laser not turning off between cuts? (burning during travel moves)

If you have a GRBL device, and your laser is still on when moving between shapes, like this: [image] It most likely means you are using GRBL 1.1f or later, but do not have the controller in Laser Mode. Fix this by typing $32=1 in the Console window and pressing enter If you have a Ruida or other DSP controller and are seeing this happen, it is most likely a dying high-voltage power supply unit (PSU). The drive circuit that turns the laser power off and on tends to go first, before the part …

This is worth review, Documentation/CommonGrblSetups.md at master · LightBurnSoftware/Documentation · GitHub

And this as well, Output issues - LightBurn Software Documentation

[pattymoelle]

Thank you that fixed the line problem. I still have a problem with burning the mirror image when i did not tell it to.

[Rick (Technical Evangelist)]

@pattymoelle

I still have a problem with burning the mirror image when i did not tell it to.

Did you check out the link I provided? What happens when you adjust this setting?

@Rick

And this as well, Output issues - LightBurn Software Documentation

[pattymoelle]

Oh yes i did read them and it did fix the transvers lines burning. Now about the mirror image. When i try to “move” the laser goes in the opposite direction. My origan is set to 0 0 and starting from left front

[pattymoelle]

Thank you for helping me I am an old women with a new toy. Tring to make and extra buck