Trying to cut small circles - not completely cutting

[cggorman (Chris)]

@HoutmeyersP is/was fighting the exact same problem here:

Cutting very small circles or parts

…often leaves the inner parts/circles hanging inside the hole with a tiny uncut part. Its like a 360°cut sometimes does not fully get to a complete 360°. Is there an option or manner in lightburn to set the laser to overshoot 360° hole or a line by a few degrees or mm so the parts would drop out clean ? For bigger parts it a non issue because the parts are easely removed by hand…but when cutting a lot of very small parts i need to push them out using a needle. I read about the tabs…this is not w…

Maybe you two can compare notes…