# Tumblers with either chuck or rotary

**URL:** <https://forum.lightburnsoftware.com/t/tumblers-with-either-chuck-or-rotary/143503>\
**Category:** LightBurn Software Questions\
**Tags:** rotary\
**Created:** [July 7, 2024, 10:45pm UTC](https://forum.lightburnsoftware.com/t/tumblers-with-either-chuck-or-rotary/143503 "2024-07-07T22:45:12Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![patriciadugas](https://forum.lightburnsoftware.com/letter_avatar_proxy/v4/letter/p/c67d28/32.png) [@patriciadugas](https://forum.lightburnsoftware.com/u/patriciadugas)\
**Post date:** [July 7, 2024, 10:45pm UTC](https://forum.lightburnsoftware.com/t/tumblers-with-either-chuck-or-rotary/143503/1 "2024-07-07T22:45:12Z")

</div>

tumblers-OK I fixed the jumping around. that was it getting stuck .3 in 1 oil fixed. but it works ok then i come back to use it again a day later it forgets everything . the y axis when i frame goes all the away over to the right and hits and just bounces. its like it cant figure out where to start from so it just goes all the way over. i have both the rotary and chuck it does it for both . im so tried of this damn thing. works great for flat items.

---

<div class="post-metadata">

**Author:** ![parsec](https://forum.lightburnsoftware.com/user_avatar/forum.lightburnsoftware.com/parsec/32/118933_2.png) [@parsec](https://forum.lightburnsoftware.com/u/parsec)\
**Post date:** [July 8, 2024, 9:45pm UTC](https://forum.lightburnsoftware.com/t/tumblers-with-either-chuck-or-rotary/143503/2 "2024-07-08T21:45:28Z")

</div>

Check if this topic helps.

> [@Setting up a Rotary Chuck or Roller](https://forum.lightburnsoftware.com/t/setting-up-a-rotary-chuck-or-roller/142443):
>
> I now have both a Chuck and a Roller rotary unit. I have done some testing in an effort to make some sense of the needed settings. The Chuck rotary is an xTool RA2 Pro and the Roller rotary is an Atezr KR. Both machines used are the Sculpfun S30 Pro and the SF-A9 (GRBL controllers). Because most rotary units use the same size stepper motor, this information may be relevant to nearly all setups. But no warranty. I will not get into all the stuff you have to switch when attaching the rotary here.…

---

<div class="post-metadata">

**Author:** ![system](https://forum.lightburnsoftware.com/user_avatar/forum.lightburnsoftware.com/system/32/64335_2.png) [@system](https://forum.lightburnsoftware.com/u/system)\
**Post date:** [August 7, 2024, 9:45pm UTC](https://forum.lightburnsoftware.com/t/tumblers-with-either-chuck-or-rotary/143503/3 "2024-08-07T21:45:45Z")

</div>

Closed on August 7, 2024, 9:45pm UTC

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.
