Bob2299
(Bob Hewson)
1
Comleted new TTS 55. Runs using LaserGRBL and T2Laser, but unable to setup properly with lightburn.
I am attempting to run on HP laptop using Win10, no success Also using ASUS Win 11.
Set up laser manually as Merlin, laser screen.shows “Ready”, Move screen does nothing, Console shows “Waiting for connection…”.
Any suggestions to get me underway?
Bob
Screen grabs below.
Read through this Topic. Fairly thorough exploration of connecting to a Marlin controller.
Bob2299
(Bob Hewson)
3
In manual device setup I chose ‘Marlin’ (not sure why) but was told I should have chosen ‘Grbl’.
Made the change, problem resolved.
Bob
system
(system)
Closed
4
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.
