Before upgrading to 1.7.06 I was able to have two instances of Lightburn open and when one finished engarving I could just go to the new screen and start cutting again. But now when I go to engrave from the new job A) the program won’t connect and shows disconnected or B) if I change the com port in Lightburn to say com 3 ii shows ready but won’t do anything. I tried to get devices to find my computer but nothing is found
Not required, worked out what I was doing wrong from previous. Had to disconnect the previous instance to get the second instance working
3 Likes
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.