Your profile says “K40” in the machine type, and your laser is called “Laser1”, so I have no idea what firmware you’re using, or with which board.
A K40 is not 400 x 400, and the way you specify the size of the machine is dependent on the controller you have. For example, if it’s GRBL, you’d change the $130 and $131 values in the firmware: Grbl v1.1 Configuration · gnea/grbl Wiki · GitHub
The settings in LightBurn don’t change the size on the controller, they just tell LightBurn how big an area to use, and should match what you’ve set in the controller itself.
“Go to origin” in LightBurn just sends the laser head to whatever value you’ve previously set as the User Origin using the ‘Set Origin’ button, not the origin of the machine.
It was a modified k40 basically. Using the m2 nano julong board and I replaced with cohesion 3D. The area is 400 x 400 and I had no problems with the m2 board and k40 whisperer before. Its running smoothieware on the board now.
When i connected the machine it didnt find the device until i added it in manually. Since I needed 3 machines I called it laser 1.
I changed the values as stated in smoothie to proper values. Im still getting issues tho and reading it as x 0 and y 400 in the software when it should be at 0.0. Any idea what Im doing wrong or issue is?
The rear-left point is 0x, 400y if the Y axis is 400mm long. The origin (0x,0y) is the front-left of the machine. This is normal Smoothieware operation.