Updated from 0.9.20 to 0.9.21 can't connect anymore

[Rick (Technical Evangelist)]

@LightBurn

For everyone piling on to this thread, unless you have the same controller and the same computer, and are connecting the same way, it’s much simpler for us to help you if you start a new thread,

@jerrylowery, You are working with a different control system than the OP.

@tellblom

I can’t connect to my laser anymore (GRBL 1.1).

Please review the following and share what Trocen model you have there in that post.

Connecting problem

Here’s the new topic about my connecting problem. I am working with a Trocen AWC708C LITE Firmware 0.1.1.5.31 and connected by USB It is connected to a computer with is running on W10 Pro When i do a job i have to unplug the usb plug and put it back in the machine. Then I do a rightclick on the device button in LB and than press start, the job is starting now. For the next job a have to do the hole cycle again. I am running LB version 9.22 Hope that there is a solution because its driving me …

Also, please explain what this means, I do not understand the issue here.

@jerrylowery

can send files but can use print/cut function