Using Milmage With An Axiom Iconic 6

MillMage Software Questions
1

I have an Axiom Iconic 6 CNC that uses a RichAuto B11 controller. These machines are not configured for direct control from a computer. Rather, files are transferred from the design software in the computer to the CNC’s RichAuto controller via USB thumb drive. I’ve been using Vectric VCarve Pro for this purpose for a number of years.

I use Lightburn for Gweike Cloud 38W CO2 laser. So I’m very familiar and comfortable with that software. I like that Milmage is very similar in appearance to Lightburn. So I’d like switch from VCarve Pro to MillMage

2

MillMage produces GCode as output, which you can then load into your controller. :slight_smile:

3

I have an Axiom Iconic 6 CNC that uses a RichAuto B11 controller. These machines are not configured for direct control from a computer. Rather, files are transferred from the design software in the computer to the CNC’s RichAuto controller via USB thumb drive. I’ve been using Vectric VCarve Pro for this purpose for a number of years.

I use Lightburn for Gweike Cloud 38W CO2 laser. So I’m very familiar and comfortable with that software. I like that Milmage is very similar in appearance to Lightburn. So I’d like switch from VCarve Pro to Milmage. But is Milmage set up to save CNC files to a USB thumb drive, then transferred to the RichAuto controller on my CNC machine ?

4

Many thanks !

1 Like
5

Yes. It won’t offer direct control, but you can export the generated GCode files to be loaded into and run from your controller.

2 Likes