Ich habe Buchstaben aus gelasert. Die Verfahrwege wurden mit auf das Material gelasert. Kann man das einstellen?
I lasered out letters. The travel paths were also lasered onto the material. Can this be adjusted?
Ich habe Buchstaben aus gelasert. Die Verfahrwege wurden mit auf das Material gelasert. Kann man das einstellen?
I lasered out letters. The travel paths were also lasered onto the material. Can this be adjusted?
This is usually caused by not having configured laser mode ($32=1). This was discussed here with other troubleshooting steps.
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.