After upgrading to 2.0 there are a fair amount of things that seem quite different. I’m working my way through them but I am stuck on the cleaning pass.
I have it setup but I want it to clean after around 10 engraving layers. I don’t see a way to do that any longer.
I’m surprised at all the things that have changed for engraving coins. Its a bit preplexing why these changes were needed but I assume for the right reasons. The lack of “hey this is different” tutorial is a bit perplexing.
When you enable cleanup in the cuts settings editor, it opens a new tab called cleanup where you can enter this and do a lot more.