Warum brennt der Laser die Wege?

[Kluntje (Manfred)]

Warum brennt der Laser die Wege ??

Why does the laser burn the paths ??

[Rick (Technical Evangelist)]

You have not provided nearly enough information to assist anything more than a guess. Your profile has only “30W” without identifying the motion control system or firmware used to drive this system. Please update your profile and provide more details here.

So my guess…, I will assume you are using a GCode system using Grbl, but you can correct me with the details.

Traversal Lines are being burnt for text created in Lightburn

A number of things: Using the “GRBL” device in LightBurn with GRBL firmware older than 1.1f (you need to use GRBL-M3 for these) If using GRBL 1.1f or later, not having Laser Mode enabled ($32=1) Not having the S-Value Max setting correct. It defaults to 1000, which is the default for new versions of GRBL, but older uses 255, and some other software sets it differently. (The S-Value Max setting in Device Settings in LightBurn must match the max spindle value your GRBL expects) See the “Short…