What I would like MillMage to have

MillMage Software Questions
1

What I would like MillMage to have.

  1. Stock to Leave as the last pass, not like it is now (I have to create a second file for the same cut, a big waste of time).
  2. On the table I have 10 designs to cut with a 3mm tool with Stock to Leave. It doesn’t cut each design completely but it goes through the first profile for all and then the second for all. For whatever reason it stops the project I have to run it all over again.
  3. I haven’t found a way to create a v-Bit flatten tool. (If anyone knows, please help me with this).

Thank you.

1 Like