Where to place camera Ortur 15w laser

[rnx22 (anthony irwin)]

Where do you place/mount the camera for a Ortur 15w laser? I printed the mount and it’s secure.

Thanks!!!

[LightBurn (Oz)]

Directly over the center of the working area, so the camera can see just a little more than the whole work area, and in a way that neither the camera or machine can move.

[doman5656 (DOM)]

is there a file to make a structure to hang over the center

[LightBurn (Oz)]

No - we have mounts available for mounting inside the lid of a closed laser, but nothing like that for open frame systems. You’d need to come up with something on your own.

[rnx22 (anthony irwin)]

Approximately how many inches Is that? Could you use a camera tripod?

[LightBurn (Oz)]

You have said “the camera” - there is no “the camera” - there are specific cameras, like our 8MP-75, or the 5MP-160, and all of them have different mounting requirements that depend on the size of the work area of the machine.

What camera do you have? If you click Help > Camera Selection Help in LightBurn, it will tell you the minimum heights for each of the cameras we sell based on your entered bed size.

[doman5656 (DOM)]

This may work but I’ll have to calibrate every time

[doman5656 (DOM)]

At the moment the calibration isn’t working out well

[LightBurn (Oz)]

That very strong shadow across the image isn’t going to help, and the pattern is too small in the camera view.

The camera doesn't find the lens calibration pattern (pattern NOT found)

The most common problems people have with the lens calibration are as follows: Honeycomb bed is visible, confusing the circle-finding code. Cover the honeycomb with a bed sheet, cardboard, paper, wood, etc. Camera isn’t in focus. Focus the camera as well as you can to get a clear image. All of the LightBurn cameras are manually focused by twisting the lens Calibration pattern is too small (or too large) in the view - you want the pattern to fill roughly one of these squares for each c…