# Why had this happened with an image

**URL:** <https://forum.lightburnsoftware.com/t/why-had-this-happened-with-an-image/26794>\
**Category:** LightBurn Software Questions\
**Created:** [November 25, 2020, 4:31pm UTC](https://forum.lightburnsoftware.com/t/why-had-this-happened-with-an-image/26794 "2020-11-25T16:31:49Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![Scheltsy63](https://forum.lightburnsoftware.com/letter_avatar_proxy/v4/letter/s/6bbea6/32.png) [@Scheltsy63](https://forum.lightburnsoftware.com/u/Scheltsy63)\
**Post date:** [November 25, 2020, 4:31pm UTC](https://forum.lightburnsoftware.com/t/why-had-this-happened-with-an-image/26794/1 "2020-11-25T16:31:49Z")

</div>

While engraving an image, the engraving left a gap on a customer’s Oak board, when re did it again on scrap it worked fine

 ![IMG_20201125_152728](https://forum.lightburnsoftware.com/uploads/default/original/3X/e/9/e9c2cea0d67c359961d14464dc630afa6c269523.jpeg) ![IMG_20201125_152713](https://forum.lightburnsoftware.com/uploads/default/original/3X/9/7/979f4a337f212210befc2a72bcfe85302e92e46b.jpeg) ![16063218561343512162876984945464](https://forum.lightburnsoftware.com/uploads/default/original/3X/7/2/72813995e13e0b3833e3035afe86a3f983d06c1a.jpeg)

---

<div class="post-metadata">

**Author:** ![system](https://forum.lightburnsoftware.com/user_avatar/forum.lightburnsoftware.com/system/32/64335_2.png) [@system](https://forum.lightburnsoftware.com/u/system)\
**Post date:** [December 25, 2020, 4:31pm UTC](https://forum.lightburnsoftware.com/t/why-had-this-happened-with-an-image/26794/2 "2020-12-25T16:31:53Z")

</div>

Closed on December 25, 2020, 4:31pm UTC

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.