Will the latest Lightburn Software run an older AP SN-4024 laser?

My laser uses a Leetro MPC6536 controller. Thanks for the help

From the home page they support

We currently support most Ruida, Trocen, TopWisdom, and GCode based controllers. Supported GCode controllers,include Grbl, Smoothieware, Grbl-LPC, and Marlin. Supported Ruida controllers include the RDC6442G/S, RDC6445G, RDC6332G, RDLC-320A, and R5-DSP. Supported Trocen controllers include the AWC708C, AWC608, and TL-3120.

Here is a link to the ‘requests’ area that pertains. Read through this, although it appears rather old.

Here is a link from July of 21…

Good luck


As stated, LightBurn does not support Leetro controllers. However, if you contact AP Lazer, they do sell a plug-in kit to upgrade your machine to a Ruida controller that is supported. As I understand it, it’s a pretty simple swap with the kit they sell.

Thanks very much

1 Like

Ok great thanks

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.