Writing programs?

Hello, new to the desktop diode lasers. About 30 yrs ago I ran a Mazak Turbo 48 1500watt laser. I got fairly good at writing programs using G code. Is that possible with Lightburn?

No, you cannot directly edit the gcode before it’s sent to the laser. You can, however, save to a .gc file from lightburn and then edit that and send it to the laser using other software.

Thanks for the reply. Although it’s been close to 30 yrs I still remember quite a bit about the programming. When they came and setup the machine in our plant I was amazed at how fast that Tech punched in those commands. I thought some day I would be programming that fast and it didn’t take long and I was.

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.