X and Y step calibration procedure in LightBurn

Getting the last items taken care of on setting up and dialing in my new laser and new LB software, I really like LightBurn and its ease of use.
I am fairly sure I understand how to do this but would like someone to confirm the steps I need to perform.
Go to x step in Mach settings, READ then make change then WRITE then ok, same for Y step Is this correct?

Yes, that’s correct. Technically you don’t have to hit ‘Read’, as it does that automatically when you enter that screen.

Thanks Oz
everything set up and calibrated now and the software, camera and machine are all Humming.

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.