# X axis problems

**URL:** <https://forum.lightburnsoftware.com/t/x-axis-problems/55242>\
**Category:** Ortur Lasers\
**Created:** [December 24, 2021, 6:32pm UTC](https://forum.lightburnsoftware.com/t/x-axis-problems/55242 "2021-12-24T18:32:14Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![king9471](https://forum.lightburnsoftware.com/letter_avatar_proxy/v4/letter/k/53a042/32.png) [@king9471](https://forum.lightburnsoftware.com/u/king9471)\
**Post date:** [December 24, 2021, 6:32pm UTC](https://forum.lightburnsoftware.com/t/x-axis-problems/55242/1 "2021-12-24T18:32:14Z")

</div>

My X axis motor and bracket is loose on the travel bracket how can it be tightened?

---

<div class="post-metadata">

**Author:** ![berainlb](https://forum.lightburnsoftware.com/letter_avatar_proxy/v4/letter/b/85f322/32.png) [@berainlb](https://forum.lightburnsoftware.com/u/berainlb)\
**Post date:** [December 24, 2021, 6:57pm UTC](https://forum.lightburnsoftware.com/t/x-axis-problems/55242/2 "2021-12-24T18:57:43Z")

</div>

Check out this post from @OrturTech. This may be what you’re talking about. If not, please elaborate.

> [@Help needed - OLM2 with Neje A40640 has Parkison](https://forum.lightburnsoftware.com/t/help-needed-olm2-with-neje-a40640-has-parkison/50860/4):
>
> The eccentric nuts purpuse is exactly to do this. they rotate but dont “tight” they snug the wheels UP or down The way you have it set up its a bit tricky you have too much mass above and below the attachement point There is something you can try, which is a try only, add mass to the back to counter balace it. like balaster Heres the main problem One is trying to fight 3 “deamons” at once You bought a more powerful module to gain speed But by its specificities the module needs …
