X axis wont continuous jog in positive direction

Hello,

Having an issue I am hopping someone can help with. I am using a Ruida rdc6445g and having a jogging issue.

The X axis will not continuous jog in the positive direction, negative is fine as well as both directions of Y. In incremental jog the machine will move in the positive x direction without issue, as well as running files, its only in the continuous job mode does it have issues.

Thanks for any help.

There are red leds on the motor drivers that will show a hardware error along with one on the controller if it has a problem.

Seems to be hardware related… you didn’t change anything in the Ruida configuration did you?

:smile_cat:

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.