Before the update I used the xtool d1 with rotary attachment with no issues. Everything was proportional and engraved perfectly. I updated the firmware and software for creative space and after that update I went to use the rotary tool just like each time before and it didn’t work properly. It spun continuously when framing a job and then spun way too much when I did a practice tumbler. I messaged lightburn support and changed the rotary setup and it stopped turning as much and at least did a job. However when I did the job on a practice yeti it wasnt proportional. It turned a square into a rectangle and now I can’t get it to work right. Does anyone have the same issue or know what to set the rotary to so it’ll work again like before?
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.