xTool S1 rotary (ra2) and lightburn: 100EUR reward!

[Aaron.F (Aaron)]

@s1user

(i question my sanity at this point)

I can assure, it’s not you!
They are doing undocumented things.

did you see this section?

@JoeSpanier

Rotary Mode
Because xTool uses the U axis for rotary this setup is a bit confusing. Go to the Rotary Dialog and check Enable Rotary and do your setup as normal. You do not need to pick your Axis as this is done automatically for the S1 in this device type.