Y+ moves y + but y- also moves y + only in light burn

So I turn my mega v xl with Jtech 24 watt quad pro on today and my y- axis jogs in y+ and y+ also moves in the + direction no settings have been changed and I have ran several successful projects in light burn all homing directions are working properly and everything works fine in both open builds and UGS only happens in light burn and only y- jog direction

anyone?? I can save the gcode and load into UGS and it works just fine only when jogging both Y direction buttons go the same way again only happening in lightburn

Thanks

Not sure why still yet but I shut everything down let it set and then started working normally hopefully was just a glitch that won’t happen anymore fingers crossed

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.