Z axis is not lowing on Snapmaker 2.0

After the first trials with laser burning the last print stopped. It was a “cut selected layer”. Trying to print that again I do have the problem that the Z axis is not lowering anymore. I restarted the printer and lightburn several times without success. When starting X and Y axis are moving to correct starting position, Z axis stays at home position. Laser starts from there.

No idea what’s going wrong, any suggestions ?!

Did you enabled “Enable Z axis” in the basic settings inside device settings menu?

Your’e right. Thanks the point. Didn’t do that!

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.