# Z-Tech Fiber Laser Compatibility

**URL:** <https://forum.lightburnsoftware.com/t/z-tech-fiber-laser-compatibility/191429>\
**Category:** OS Specific\
**Created:** [July 24, 2026, 4:22pm UTC](https://forum.lightburnsoftware.com/t/z-tech-fiber-laser-compatibility/191429 "2026-07-24T16:22:04Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![uaspilot1](https://forum.lightburnsoftware.com/letter_avatar_proxy/v4/letter/u/7993a0/32.png) [@uaspilot1](https://forum.lightburnsoftware.com/u/uaspilot1)\
**Post date:** [July 24, 2026, 4:22pm UTC](https://forum.lightburnsoftware.com/t/z-tech-fiber-laser-compatibility/191429/1 "2026-07-24T16:22:04Z")

</div>

Hi, has anyone here successfully used LB with a Z-Tech fiber laser? I have tried too many methods to even list but still no success.

---

<div class="post-metadata">

**Author:** ![joed](https://forum.lightburnsoftware.com/user_avatar/forum.lightburnsoftware.com/joed/32/65276_2.png) [@joed](https://forum.lightburnsoftware.com/u/joed)\
**Post date:** [July 24, 2026, 7:08pm UTC](https://forum.lightburnsoftware.com/t/z-tech-fiber-laser-compatibility/191429/3 "2026-07-24T19:08:55Z")

</div>

Most Z-Tech lasers use either EzCad2 or EzCad3, and the setup can be slightly different between the two, but they use the same driver.

Are you able to get LightBurn to connect to your laser at all? Or, once connected, your laser doesn’t perform as you’d expect?

Have you done the legacy driver swap as shown in our documentation [here](https://docs.lightburnsoftware.com/latest/Guides/GalvoDriverInstallation/?h=swap#legacy-zadig-based-driver-swap)?

On that same page, there is also a section that will show you how to verify that your driver was correctly installed.

\*(Page linked above: [Legacy Zadig-Based Driver Swap](https://docs.lightburnsoftware.com/latest/Guides/GalvoDriverInstallation/?h=swap#legacy-zadig-based-driver-swap))\*

---

<div class="post-metadata">

**Author:** ![system](https://forum.lightburnsoftware.com/user_avatar/forum.lightburnsoftware.com/system/32/64335_2.png) [@system](https://forum.lightburnsoftware.com/u/system)\
**Post date:** [August 23, 2026, 7:09pm UTC](https://forum.lightburnsoftware.com/t/z-tech-fiber-laser-compatibility/191429/4 "2026-08-23T19:09:04Z")

</div>

Closed on August 23, 2026, 7:09pm UTC

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.
