I did the 2.0 update and now when cutting shapes it takes forever because for some reason evertime an inner shape is cut the laser head moves approximately 3 inches like its going to home then it moves back to do the next cut. I cant find a way to fix.

See here for further discussion: [image] Laser moves diagonal after every cut LightBurn Software Questions I just installed the latest update. I did not change any setting from the previous version. Now after every cut, every engraving the laser moves diagonal towards bottom left for about 15 mm… 2 secs, (sometimes up to 6 seconds travel before it goes back to burning). When engraving 200 + lines I loose 400 seconds of work time. Just annoyed at this useless move which was not there before. Any idea what the cause can be? Made a clip but can’t upload it here. Now a simple 1.5 min project to en…

Have got the same problem with Sculpfun Laser and Framing also y first then x

I also have a similar problem. The laser preview frame is not what the laser does when set to burn. It makes one small cut and then wanders toward the right front corner, very slowly but never returns to the cut. Tried to make a material test, did a preview frame, that works right but when I start the test the laser head quickly slams into either the side or end rail and keeps bashing the laser head against the rail until I hit stop. It does not follow the preview frame area. Dumped 2.0 and went back to 1.7.08 after destroying a 12x24x 3mm board

You can try to remove the laser and add it new. It’s done in two minutes, and then all issues should be gone.

2.0 cutting shapes problem

LightBurn Software Questions

misken (Melvin) July 10, 2025, 6:15am 2

See here for further discussion: