2.1.04 Update: Rotary mode faster with update

[hartwics (Shannon Hartwick)]

Rotary mode: Not responding to slower speed settings. It is engraving too fast, and ignoring the parameters already set in place. Is this something from the new update? going back to old one for now. Engraving speed only on rotary is way too fast, and checked all my machine settings, vendor settings etc… I dont understand why its doing this.

[parsec (FerAS)]

Load a prefs backup from when it worked.
Also check for the control units.

[MikeyH (Mike Hembrey)]

These control units. Also if you switch between Metric and Imperial in the design window (device units), you might want to turn off the linking too.