Does “Absolute Coords” work as expected?
We’re using a new protocol for xTool since RC-2, and I’m wondering if the laser always homes first when sending it a job.
So, if you can test this:
- Jog to the middle of the workarea
- Set Start From to “Absolute Coords”
- Engrave a simple rectangle in the middle of the workarea.
Does it home before starting the job, or start from the middle?
A coleague sent me his device profile we used for testing this. Can you import this to ensure we’re using the same settings?
xTool-S1-40w.lbzip (1.9 KB)
(Updated to remove the Start GCode)